Steps for Auto-Tuning Frequency Converter

1.  Push round button until “CONF” appears on the Pinabar. Turn right until “FULL” appears.
2.  Push round button to accept. Turn right until “DRC” appears.
3.  Push round button to accept. Turn right until “N5P” appears.
4.  Set RPM to 7370. Push round button to accept.
5.  Turn right until “RUN” appears. Push round button to accept.
6.  Turn right until “YES” appears. Make sure relay is 12K5 is activated.
7.  Activate 21KP or 21KG with screwdriver. Push round button to accept.
You will hear a short noise from converter. The conleaks is ready now.
Push “ESC” until “RDY” appears.